FOXCART MARK II GROUND POWER UNIT 

The Foxcart ground power unit is designed to provide smooth, high current DC power to aircraft during engine starts or ground maintenance. The Foxcart, when used as an external DC source, eliminates or minimizes excessive current drain from the aircraft’s battery and battery relay contacts. It is also designed as a low profile unit that requires minimum ventilation and is easily moved in a crowded hangar by one person.

 All units are provided in functional configuration with standard 15ft. DC cables with a Anderson Aircraft DC plug and 50ft. AC cable with a Hubbell 460P7W AC plug.

Model 1200: This is a single-phase power input unit and should only be considered if three-phase power is not available. It will deliver the rated DC power, but with less efficiency and regulation than the other models. It can handle starts on helicopters and other light aircraft and will greatly assist a battery start on heavier aircraft.

Output Volts: 28VDC

Peak DC Out: 1200 AMPS

Continuous DC Out: 600 AMPS

Input Power Required: 208-240 Volts Single Phase 200 AMPS Service 

Model 1600: * This power unit requires three-phase power in-put.

Output Volts: 28VDC **  
Peak DC Out: 1600 AMPS  
Continuous DC Out: 800 AMPS  
Input Power Required: 208-240 Volts Peak 100 AMPS Service 380-480 Volts Peak Three Phase 50 AMPS/per phase Three Phase 70 AMPS/per phase

* Other voltages available upon request.

 ** The above ratings are based on the point where voltage sags to 23 volts.

*** Required for engine starts only.   
 
Model 2000: * This power unit delivers maximum 2000 Amps output.

Output Volts: 28VDC **

Peak DC Out: 2000 AMPS

Continuous DC Out: 1000 AMPS

 Input Power Required: 208-240 Volts Peak Three Phase 100 AMPS/per phase 380-480 Volts Three Phase 70 AMPS/per phase ***

* Other voltages available upon request.

** The above ratings are based on the point where voltage sags to 23 volts.

 *** Required for engine starts only. 60 cycle AC input current per leg at peak load for 30 seconds maximum
 
 

The Foxcart is enclosed in an all steel chassis frame with a three-piece steel box siding. There are handles at each end to move it. The power cables can be wrapped around the handles or coiled on top for storage. The wheels can be locked in place to prevent movement. Both power cables are clamped internally to the frame for strain relief. The controls marked “optional” are not included in the standard  Foxcart unless ordered by the customer.

Foxtronics warrants each new Foxcart Mark II Series to be

free of defects in material and workmanship, under normal

use and service for three years from date of shipment.

Dimensions including handles:

Standard Model Foxcart: Length 50.50” Width 30.00”

Heigth 31.50”

With Terrain Wheels: Length 50.50” Width 30.00”

Height 38.00”